2008-2010 Powerstroke 6″ 4 Link Lift Kit (BDS560H)

Beschreibung

Klicken Sie hier, um dieses Kit zu personalisieren

Passt zu

?

Your 6.4 is a Powerhouse that can eat up miles like no other! Match the power of the beast under the hood by lifting your truck with a 4-Link conversion 6″ lift kit. Designed to make sure you don’t lose any control while you increase the stance,?this also will reduce caster change through wheel travel maintaining controllability on & off-road.??

Teil Nummer:?BDS560H

Eigenschaften

• 6″ ProRide Coil Springs
• Lenkungsstabilisator
• Anti-Sway Bar Drop Brackets
• Geschmiedeter Lenkstockhebel
• Spurstangenversetzungshalterung
• NX2-Serie Stoßdämpfer
• 5″ Rear Block Kit
• Löscht 37's
• OE Driveability

Reifen- und Radkombinationen:

• 37″ x 13,50″ mit 17 x 9 und 4,5″.
• 37″ x 13,50″ mit 18 x 9 und 4,5″.
• 37″ x 13,50″ mit 20 x 9 und 4,5″.

Anmerkungen

• Removal of the factory block is required.
• Installation of the rear block kit will result in a “pre-runner” look with the rear of the vehicle 2″ lower than the front. To get a level stance you must upgrade to the rear leaf spring option.
• These trucks were manufactured with and without top-mounted overload springs on the rear leaf springs. A top-mounted overload is an extra leaf separate from the pack that is set above the main leaf. You will need to identify which you have before ordering.
• If your vehicle is equipped with a carrier bearing, you will need to order 123402 in the options section.
• Obwohl extrem selten, können Vibrationen des vorderen Antriebsstrangs auftreten.
• Front exhaust modification may be required to clear the front driveshaft on gas models.
• U-Bügel passen nicht auf Dually-Modelle.
• Dropped pitman arm will not fit 10 lug wide track F350 models.

Einrichtung

• Klicken Sie hier für Installationsanweisungen
• Schwierigkeit: 3 (wobei 1 = einfach und 5 = kompliziert)